Start up - Air Compressor
START-UP SHEET
Air Compressor
START-UP SHEET 1601 Las Plumas Ave.
Air Compressor Ph: (408) 347-3400
Job Name Job Number
Job Address
Section 5: Equipment Description
| Spec. #: | Submittal #: | P&ID / Dwg #: |
|---|---|---|
| Area Served: |
| Air Compressor Data | Design | Actual On Site |
|---|---|---|
| Unit Tag # | ||
| Manufacturer | ||
| Model # | ||
| Serial # |
| Air Dryer Data | Design | Actual On Site |
|---|---|---|
| Unit Tag # | ||
| Manufacturer | ||
| Model # | ||
| Serial # |
| Belt Description | |||
|---|---|---|---|
| Size&Quantity |
Section 6: Equipment Pre-Installation Inspection
| Step | Inspection Description | Yes | No | N/A | Performed By(Initials & Date) |
|---|---|---|---|---|---|
| 6.2 | Nameplate data matches vendor specifications. | □ | □ | □ |
Comments/
Observations
Performed By
(Therma)
Reviewed By
| Print Name | Signature | Date |
|---|---|---|
(Owner/Representatives)
START-UP SHEET 1601 Las Plumas Ave.
Air Compressor Ph: (408) 347-3400
| Step | Inspection Description | Yes | No | N/A | Performed By(Initials & Date) |
|---|---|---|---|---|---|
| 6.3 | All parts are received. | ☐ | ☐ | ☐ | |
| 6.4 | No visible signs of damage, leak, or defective parts. | ☐ | ☐ | ☐ | |
| 6.5 | Verify electrical service for correct voltage, current and thermal overload protection. | ☐ | ☐ | ☐ | |
| 6.6 | Operational and Maintenance(O&M) manual is available in field. | ☐ | ☐ | ☐ | |
| 6.7 | Start-up technicians have reviewed factory start-up procedures in O&M manual. | ☐ | ☐ | ☐ |
Section 7: Installation Inspection
| ID | Inspection Description | Yes | No | N/A | Performed By(Initials & Date) |
|---|---|---|---|---|---|
| 7.2 | Unit is installed level and is covered or out of weather. | $\Box$ | $\Box$ | $\Box$ | |
| 7.3 | Tag # is attached to the unit. | $\Box$ | $\Box$ | $\Box$ | |
| 7.4 | Service clearance is adequate for maintenance. | $\Box$ | $\Box$ | $\Box$ | |
| 7.5 | Compressor pump is lubricated. | $\Box$ | $\Box$ | $\Box$ | |
| 7.6 | Drive belt tension is correct. | $\Box$ | $\Box$ | $\Box$ | |
| 7.7 | Pulleys are aligned and tight. | $\Box$ | $\Box$ | $\Box$ | |
| 7.8 | Air inlet, oil filters,and discharge filters are installed properly. | $\Box$ | $\Box$ | $\Box$ | |
| 7.9 | Compressor oil level is within manufacturer's specification. | $\Box$ | $\Box$ | $\Box$ | |
| 7.10 | Guard is secure. | $\Box$ | $\Box$ | $\Box$ |
Observations
(Owner/Representatives)
| Print Name | Signature | Date |
|---|---|---|
START-UP SHEET 1601 Las Plumas Ave.
Air Compressor Ph: (408) 347-3400
| Step | Inspection Description | Yes | No | N/A | Performed By(Initials & Date) |
|---|---|---|---|---|---|
| 7.11 | Auto drains are installed on tank and run to sanitary or condensate separator. | $\Box$ | $\Box$ | $\Box$ | |
| 7.12 | All wiring connections are tight. | $\Box$ | $\Box$ | $\Box$ | |
| 7.13 | Drain is piped properly. | $\Box$ | $\Box$ | $\Box$ | |
| 7.14 | Air dryer is installed. | $\Box$ | $\Box$ | $\Box$ | |
| 7.15 | Oil separator is installed. | $\Box$ | $\Box$ | $\Box$ | |
| 7.16 | Oil separator drain is run to condensate management system. | $\Box$ | $\Box$ | $\Box$ | |
| 7.17 | Condensate management system is installed for oil separation. | $\Box$ | $\Box$ | $\Box$ |
Section 8: Operational Inspection
| ID | Inspection Description | Yes | No | N/A | Performed By(Initials & Date) |
|---|---|---|---|---|---|
| 8.2 | Unit vibration is acceptable. | $\Box$ | $\Box$ | $\Box$ | |
| 8.3 | Motor rotation is correct. | $\Box$ | $\Box$ | $\Box$ | |
| 8.4 | Air dryer is functional. | $\Box$ | $\Box$ | $\Box$ | |
| 8.5 | Oil separator is functional. | $\Box$ | $\Box$ | $\Box$ | |
| 8.6 | Record the operating parameters below: |
| Comments/ Observations | |
|---|---|
Performed By
(Therma)
(Owner/Representatives)
Reviewed By
| Print Name | Signature | Date |
|---|---|---|
START-UP SHEET
Air Compressor
START-UP SHEET 1601 Las Plumas Ave.
Air Compressor Ph: (408) 347-3400
Record Start Up Operating Parameters
| Data | Design | Actual On Site | ||
|---|---|---|---|---|
| Unit Voltage | ||||
| Current | ||||
| Phase | ||||
| Motor Rotation(RPM) | ||||
| Horsepower(HP) | ||||
| Air Dryer Voltage | ||||
| Current | ||||
| Phase | ||||
| ΔT°F |
End of Section
Comments/
Observations
| Print Name | Signature | Date |
|---|---|---|
(Owner/Representatives)